ServersCheck Support Forum: Initial setup on Environment/Temp Monitor

server room planner

contact us

jobs

about us

Welcome Guest

ServersCheck Environmental Sensors

Subject

Topic: Initial setup on Environment/Temp Monitor

Message posted by aodell on 19 July 2010 at 13:17 - IP Logged

Standard Member

Standard Member

19 July 2010
2 Posts

I've read thru most of the other posts on this subject but didn't find the answer I needed.
Like others, my company has purchased ServersCheck's Temp Monitoring Kit a few yrs ago. The person who purchased it is long gone from our company. And of course he requested that the software not be shipped & to have it electronically downloaded.
I was able to download & set it up for the most part but couldn't find out how to monitor for temp.

I have a Lantronix/ServersCheck device - small grey box about 3" X 4", one end has ports for power & ethernet. Ethernet goes to switch.
The other end only has a port for parallel to ethernet cable. The other end of that cable goes to the temp sensor device.
That device is a little white box about 2" X 3", only one end has ports for power & ethernet.

Could someone help me in getting this setup to monitor temp?

Any help is much appreciated.....

Thanks,
Drew

-----------------
drew

Message posted by Administrator on 19 July 2010 at 19:22 - IP Logged

Forum Admin
Forum Administrator

Forum Administrator

29 March 2001
2963 Posts

Drew,

Please check http://serverscheck-manuals.s3.amazonaws.com/ServersCheck_Environmental_Sensors.pdf for instructions on how to set your sensor up.

Message posted by aodell on 20 July 2010 at 13:57 - IP Logged

Standard Member

Standard Member

19 July 2010
2 Posts

Thanks. I also needed to install SNMP. I should have time to work on this again tomorrow.

-----------------
drew

If you wish to post a reply to this thread you must first Login
If you are not already registered you must first register

Printable version